567 Starrett V blocks and clamp complete set 1-5/16 capacity

567
Starrett V-Block and Clamp
1-5/16" / 33mm Capacity

This is an improved V-block and clamp which has these very versatile
features:
Can be used on its base, on the end or on either side

• The clamp is smaller than the outside width of the block, but has
  an adjustable side screw to support the block and prevent tilting
• The V at the stepped end is at right angles to the base and is
  handy for holding shouldered studs, pins, etc.
• A clearance hole for drilling or removing dowel pins is provided in
  the block
• The block has four 3/8-16 tapped holes, two in the base and
  one on each side for attachment to an angle iron. The angle iron
  holding the block can then be attached to a lathe faceplate or held
  by a magnetic chuck
• The clamp is a strong forging
• The block is hardened and precision ground. The sides are parallel
  and the V is central and parallel to the sides and base